History shows

• Number of compressor starts

• Compressor runtime (total hours of compressor Runtime over the life of the dehumidifer)

• Ventilation time (total hours of Vent Runtime over the life of the dehumidifer)

• FW/HW/VR (firmware and hardware versions)

• Filter life months (time until filter replacement timer expires)

Settings

These settings should only be used by the installer

Relative %

Shows the RH measure by the dehumidifer at the inlet

Status

Displays the state the dehumidifier is being commanded to

• Idle

• Dehumidifying

• Ventilating

• Dehumidifying Vent Air

• Air Sampling (When using onboard control the dehumidifier runs the fan three minutes every 30 minutes to sample air from the space)

• Defrost

• Compressor Protection

Setting for Relative Humidity

Note:
The onboard control will not offer a RH setting if the installer set the dehumidifier for external control

Position of the return damper (if used)

Position of the ventilation damper (if used)

Hold Button

Note:
This button is for installer testing only

The hold mode is used to test the dehumidifier. When set in hold mode, the dehumidifier will operate in the selected mode for up to five minutes. Options for hold mode include ventilating, dehumidifying, dehumidifying vent air, and defrost.

Up and Down Arrow Buttons

These buttons adjust the Relative Humidity setting from Home Screen or adjust settings in the Setting Menu

Alerts

When an alert is active, it will shown and Alert Icon. Consult Alerts section for accessing alerts.